1. Scope 1.1 This practice covers procedures used for compression molding test specimens such as rectangular or square cross-section bars, disks, and the "dog-bone" specimens used for tensile testing. Note 1-This standard is similar in content (but not technically equivalent) to ISO 295-1974 (E). 1.2 Molding conditions are given for amino, phenolic, and allyl molding compounds. Materials specification standards should always be consulted to determine whether the material to be molded has any special requirements. 1.3 The values stated in SI units are to be regarded as the standard. The values in parentheses are given for information only. 1.4 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.