&nbsp
International Customer Service
Phone +49 30 2601-2759
Fax +49 30 2601-1263

Standard [WITHDRAWN] 2004 Article is not orderable

ASTM A 325b:2004

Standard Specification for Structural Bolts, Steel, Heat Treated, 120/105 ksi Minimum Tensile Strength

Publication date
2004
Accessibility
Original language
English
Publication date
2004
Accessibility
Original language
English

Quick delivery via download or delivery service

Buy securely with a credit card or pay upon receipt of invoice 

All transactions are encrypted

Short description
1.1 This specification covers two types of quenched and tempered steel structural bolts having a minimum tensile strength of 120 ksi for sizes 1.0 in. and less and 105 ksi for sizes over 1.0 to 1½ in., inclusive. 1.2 The bolts are intended for use in structural connections. These connections are covered under the requirements of the Specification for Structural Joints Using ASTM A 325 or A 490 Bolts, approved by the Research Council on Structural Connections of the Engineering Foundation. 1.3 The bolts are furnished in sizes ½ to 1½ in., inclusive. They are designated by type, denoting chemical composition as follows: Type Description Type 1 Medium carbon, carbon boron, or medium carbon alloy steel. Type 2 Withdrawn in November 1991. Type 3 Weathering steel. Note 1 - Bolts for general applications, including anchor bolts, are covered by Specification A 449. Also refer to Specification A 449 for quenched and tempered steel bolts and studs with diameters greater than 1½ in., but with similar mechanical properties. Note 2 - A complete metric companion to Specification A 325 has been developed - Specification A 325M; therefore no metric equivalents are presented in this specification. 1.4 The specification is applicable to heavy hex structural bolts only. For bolts of other configurations and thread lengths with similar mechanical properties, see Specification A449. 1.5 Terms used in this specification are defined in Specification F1789. 1.6 The following safety hazards caveat pertains only to the test methods portion, Section 10 , of this specification:This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Loading recommended items...
Loading recommended items...
Loading recommended items...