DIN 14800-5:2013-12

This document contains the composition of the set of multi-purpose pull devices MZ 16 and MZ 32 which are carried along on firefighting and rescue service vehicles as universally applicable means for the pulling of loads. The standard points out that, in case of possible spatial and dimensional reserves, the loading of the boxes may be supplemented as desired. The following reason is given for the modification of the previous edition DIN 14800-5 of February 2005: - since these boxes are not produced from wood, the wooden design version has been deleted; - the dividers are specified in the relevant individual standards for fire equipment boxes; - in the future, a permanently installed divider for most fire equipment boxes will be possible in addition to a variable divider. Therefore, this standard edition represents a consolidated version of the standard into which all modifications have been incorporated. This standard differs from DIN 14800-5:2005-02 as follows: - the wooden design version has been deleted; - the requirements for dividers in 6.1 have been revised; - the content of multi-purpose pull device MZ 16 has been supplemented by an edge protection; - the content of multi-purpose pull device MZ 32 has been supplemented by an equipment chest; - masses and marking have been revised; - information on the coating has been deleted. The committee responsible for this standard is NA 031-04-09 AA "Sonstige Ausrüstung - SpA zu CEN/TC 192/WG 5" ("Other equipment - mirror committee of CEN/TC 192/WG 5") at DIN.